Tether issues USDT on many blockchains. Ethereum is one of the longest-running homes for the token, and plenty of wallets and DeFi users keep their USDT there. If some of your customers do, forcing them to bridge to TRON before paying adds cost and risk. Offering USDT ERC20 removes that step.
USDT ERC20 or USDT TRC20: which should customers use?
It is the same dollar token on two separate networks. The differences are practical:
| USDT ERC20 | USDT TRC20 | |
|---|---|---|
| Blockchain | Ethereum | TRON |
| Address starts with | 0x | T |
| Fee paid in | ETH (gas) | TRX (energy and bandwidth) |
| Payfim default | 6 confirmations | Solidified transfers only |
| API key | Free Etherscan key required | None required (free TronGrid key recommended) |
The best approach for most stores is to enable both and let the customer pick the one that matches where their coins already are. Payfim shows them as two clearly labeled options so nobody picks by accident. The USDT TRC20 page has the TRON details.
How much does it cost the customer to send USDT on Ethereum?
A token transfer on Ethereum uses more gas than a plain ETH transfer because it runs the token contract's code. The fee is paid in ETH, not in USDT, so the sender needs some ETH in the same wallet. In late September 2026 Ethereum gas prices were low and a standard transfer cost well under a dollar on Etherscan's tracker; token transfers cost a multiple of that. Gas prices can rise sharply during busy periods, so treat any figure as a snapshot.
Payfim itself adds nothing on top. You receive the full USDT amount the customer sends.
How fast will the order update?
With Ethereum's roughly 12-second blocks and Payfim's default of 6 confirmations, a payment usually completes a couple of minutes after it lands in a block. The checkout shows confirming while it counts up.
Picking a receiving wallet
Any Ethereum wallet whose recovery phrase you hold can receive USDT: a hardware wallet is the safest choice, a reputable non-custodial wallet is fine for smaller balances. You can reuse the same 0x address you use for ETH and USDC. Payfim tells the coins apart by token contract, not by address.
Plan for gas: to move USDT out later, that wallet needs a little ETH.
Payfim setup for USDT ERC20
- Get a free key at etherscan.io and save it under Wallets & coins → Blockchain APIs → Etherscan API V2 key. If you already set up ETH, this is done.
- Paste your address into the Tether USDT – Ethereum (ERC20) row. It must be
0xfollowed by 40 hexadecimal characters. - Keep the confirmations box empty for the default of 6, switch the coin on and click Save wallets.
- Press Test, then create a test payment from the dashboard.
Payfim reads token transfers for the official Tether contract (0xdac17f958d2ee523a2206206994597c13d831ec7) to your address. Amounts are shown to four decimals, and each open invoice gets a slightly different amount so payments to the shared address can be told apart.
Mistakes to watch for
Sending on BNB Chain, Polygon or a layer 2
Those networks also use 0x addresses, so a wallet will happily send "USDT" there to your address. The funds may reach an address you control on that other network, but Payfim watches Ethereum mainnet only and the order will not update. Put a short note at checkout: "Send on Ethereum (ERC20) only."
Fake tokens
Tokens called "USDT" with a different contract do not count. Payfim ignores them.
Exchange withdrawal fees
If an exchange subtracts its fee from the amount, the payment may fall short of the 0.5% tolerance and the invoice is flagged underpaid. See handling crypto underpayments.
Issuer controls
Tether can freeze USDT held at specific addresses. Keep that in mind when deciding how long to leave large balances in one place.
Tips to pass on to customers paying from Ethereum
- Check where your USDT is. If it is on TRON, choose the TRC20 option instead and save on fees.
- Keep ETH for gas. A wallet with USDT but no ETH cannot send.
- Paste the amount. The QR code contains the address only; use the copy button for the exact amount.
- Do not panic about a slow transfer. If gas was set low and the transaction takes longer than the 30-minute rate lock, Payfim still detects it and records it against the invoice.
When is USDT ERC20 the wrong choice?
If most of your orders are small, say under a few tens of dollars, Ethereum gas can be a noticeable share of the basket during busy periods. In that case keep ERC20 available for customers who already hold USDT on Ethereum, but present TRC20 first. For larger B2B invoices the gas cost matters much less, and some business customers prefer Ethereum because their treasury already sits there.
Keep reading
For the stablecoin decision as a whole, read USDT vs USDC for online stores. The All-Access Bundle includes every coin on every platform module.
Sources
Third-party facts were checked on the date shown above. Prices and features of other services change - always confirm on their official pages.

